Genius Power Base
The GENIUS POWER regulators have been projected to obtain an efficiency above 99%, with reduced sizes and weights in comparison with the traditional electromechanical systems of flux regulation. The operating system is the phase cut one on II° and on IV° quadrants, namely in the phase when the positive half-wave descends and in the phase when the negative half-wave rises. This process of power control, carried out by MOS-FET devices with very high efficiency, offers considerable advantages, such as the reduction of the induced interferences on the line, the possibility to use power factor correction condensers below the regulator, the elimination of over-tensions on the output that cause the early ageing of the lamp. A special system of current reading allows to protect the regulator from short circuits on the output and to regulate the partition according to the effective value of the tension. The GENIUS POWER range consists of the following models:
Genius Power Base 18A (cod. 100290) - Technical information - [pdf]
Genius Power Base 25A (cod. 100291) - Technical information [pdf]
Genius Power Base 35A (cod. 100292) - Technical information [pdf]
Genius Power Analog
The GENIUS POWER ANALOG models, in three different powers, are predisposed to be controlled by an analogue signal 0÷10V that enters directly into the VBUS terminal.
This model has been created to be used with PLC or simply with some potentiometers. The relation between the tension of the control signal and the output tension is directly proportional. Hereafter you can find the available models.
Genius Power Analog 18A (cod. 100293) - Technical information [pdf]
Genius Power Analog 25A (cod. 100294) - Technical information [pdf]
Genius Power Analog 35A (cod. 100295) - Technical information [pdf]
Genius Power Dip
The GENIUS POWER DIP models, with three different powers, have a predefined operating procedure based on two tension levels that can be set through DIP SWITCH and time-regulated through external auxiliary devices, such as timers or crepuscular sensors.
Hereafter you can find the models of the series.
I modelli della serie sono i seguenti:
Genius Power Dip 18A (cod. 100296) - Technical information [pdf]
Genius Power Dip 25A (cod. 100297) - Technical information [pdf]
Genius Power Dip 35A (cod. 100298) - Technical information [pdf]
Genius Power Auto
The GENIUS POWER AUTO models, of three different powers, are created in order to operate autonomously according to one of the procedures that can be selected at the order (see the TENSION CURVES table). GENIUS POWER AUTO operates without any external devices and does not require any settings.
The operating procedure or TENSION CURVE can be personalized by the manufacturer according to the application requirements. The following models are available:
Genius Power Auto 18A (cod. 100299) - Technical information [pdf]
Genius Power Auto 25A (cod. 100300) - Technical information [pdf]
Genius Power Auto 35A (cod. 100301) - Technical information [pdf]
Serie Genius
Gamma dei modelli
- Genius Power Base
- Genius Power Base 2
- Genius Control
- Genius By PAss
- Genius Sensor
- Genius Compact
- Genius Booster
- T.A. Modul
Agentech produces advanced systems in the electronic and electrotechnic fields that are innovative in the following fields: continuity groups/emergency, static and electromechanical stabilizers, relays, harmonic filters, inverters, electronic components, management of the light sources and their integrations. By applying the experience of the energy conversion in the management of the fluorescent light sources, sodium vapours, mercury vapours and metallic iodides, Agentech proposes their optimisation with regulation of the required luminosity, in established time periods and in function of the sun irradiation, in order to have always the best lighting engineering level and the best management required in the specific application.
The main economical advantages are registered for both state and private fields, with great attention to hospitals, hypermarkets, industries, public service locations, railway and airport junctions and terminals, areas used for parking and service both in open and closed spaces, arterial roads and highways, galleries.